Casing string

Casing string is a long section of connected oilfield pipe that is lowered into a wellbore and cemented. The pipe segments (called "joints") are typically about 40 ft [12 m] in length, male threaded on each end and connected with short lengths of double-female threaded pipe called couplings.

Casing is run to protect or isolate formations adjacent to the wellbore. It is generally not possible to drill a well through all of the formations from surface (or the seabed) to the target depth in one hole section. The well is therefore drilled in sections, with each section of the well being sealed off by lining the inside of the borehole with steel pipe, known as casing, and filling the annular space (or at least the lower portion) between this casing string and the borehole with cement. Then drilling commences on the subsequent hole section, necessarily with a smaller bit diameter that will pass through the newly installed casing.

A liner is a casing string that does not extend to the surface, being hung instead from a liner hanger set inside of the previous casing string but usually within about 100 metres (328 ft) of its bottom. Other than the obvious cost savings, the liner installation allows larger drill pipe or production tubing to be used in the upper portions of the well. (A disadvantage is the occasional difficulty in effecting a pressure seal by squeeze cementing the casing-liner overlap zone.)

Depending on the conditions encountered (e.g., zones of differing formation pressure gradients), three or four casing strings may be required to reach the target depth. The cost of the casing can therefore constitute 20-30% of the total cost of the well. Great care must therefore be taken when designing a casing programme which will meet the requirements of the well.