Computer data storage
The terms "storage" (U.K.) or "memory" (U.S.) refer to the parts of a digital computer that retain physical state (data) for some interval of time, possibly even after electrical power to the computer is turned off. The anthropomorphic term memory has been used in the U.S. ever since the 20th century.
Different types and different purposes
There are many ways in which types of memory (fast access) or storage (slower access) can be categorised. These include the following technologies:
- primary access from the CPU or secondary (indirect) access by the CPU, which was based primarily on speed of access to the memory.
- volatile or non-volatile, which is based on the technology (magnetic vs. electrical, etc.)
- read-only memory, WORM, or read-write, again based on technology.
- Random-Access or Sequential-Access, which is based on the mechanism of reading the memory.
- Block or File access
- media categories, e.g., semiconductor storage, optical storage, magneto-optical storage, and magnetic storage, which is mainly disk-based, rather than memory-based.
Historically, "memory" referred to "magnetic core memory" in the 1950s, and then to semiconductor-based storage in the 1970s, at a time when the fastest response times were for magnetic core, and then for semiconductor memory, respectively. The evolution of usage can be glimpsed in the history of computing hardware, as the costs of the various technologies declined.
Each type of storage is suited for different purposes, and most computers contain several types: primary, secondary, and volatile.
Primary vs. Secondary Storage
In traditional parlance, primary storage contains data that are actively being used (for example, the programs currently being run and the data they are operating on). It is typically high-speed, relatively small, is often (but not always) volatile. It is sometimes referred to as "Main Memory."
Secondary storage, also known as peripheral storage, is where the computer stores information that is not necessarily in current use. It is typically slower and higher-capacity than primary storage. It is almost always non-volatile.
Confusingly, these terms are often used differently. Primary storage can be used to refer to local random-access disk storage, which should properly be called secondary storage. If this type of storage is called primary storage, then the term secondary storage would refer to offline, sequential-access storage like tape media.
Volatile storage
Volatile storage loses its contents when it loses power; non-volatile storage does not.
Random vs. Sequential Access
Random-access media has the property of accessing any portion at any time. Semiconductor memory (RAM) and magnetic disk are examples of this type of storage.
Sequential-access media by contrast must be read in sequence regardless of the desired content. Magnetic tape and certain types of flash memory have this property.
Block vs. File Access
In disk storage, these are the two primary access methods. Block access means that the disk is divided into normally equal-sized blocks which are accessed at random by the operating system. File access contains an abstraction of files and directories which can be used to refer to storage content. Another access method, content-addressable storage (CAS) uses a hashing algorithm to refer to pieces of data.
A list of storage devices
- Semiconductor Memory:
- Cache memory
- Core memory aka Ferrite core memory
- Core rope memory
- Delay line memory
- Magnetic Disk:
- Magneto Optical
- Optical Media:
- Magnetic tape
- Holographic memory
- Bubble memory
- Magnetic drum
- Memory stick
- Mylar tape
- Paper tape
- Punch card
- Selectron tube
- Smartdisk
- Thin film memory
- Williams tube