ဝီကီပီးဒီးယား:Sandbox

/*

* nRF24L01 Transmitter Test Software
* 
* Exercises the nRF24L01 Module.  This code runs on the transmitter 'Master' device.
* Use the nRF24L01_Receiver_Test software for the receiving 'Slave' device
* 
* This uses the RF24.h library which can be installed from the Arduino IDE
* Pins used for the SPI interface are determined by the Arduino being used. 
* The other two pins are arbitrary and can be changed if needed.  Redfine them in the RF24  
* statement.  Default shown here is to use pins 7 & 8
*/

1. include <SPI.h>
2. include <nRF24L01.h>
3. include <RF24.h>

RF24 radio(7, 8); // CE, CSN // Define instance of RF24 object called 'radio' and define pins used const byte address[6] = "00001"; // Define address/pipe to use. unsigned long count = 0; // Use to count the number of messages sent char countStr[10]; // Create a char array to hold count as a string //=============================================================================== // Initialization //=============================================================================== void setup() {

 radio.begin();                  // Start instance of the radio object
 radio.openWritingPipe(address); // Setup pipe to write data to the address that was defined
 radio.setPALevel(RF24_PA_MAX);  // Set the Power Amplified level to MAX in this case
 radio.stopListening();          // We are going to be the transmitter, so we will stop listening

} //=============================================================================== // Main //=============================================================================== void loop() {

 count++;                              // Increment the count
 ltoa(count,countStr, 10);             // Convert the count and put into the char array.
 char text[30] = "Sending Message: ";  // Create our base message.
 strcat (text, countStr);              // Append the count to the base message
 radio.write(&text, sizeof(text));     // Write the char array.
                       
 delay(1000);                          // Delay for 1 second, then repeat

}