Volt

The volt (symbol: V) is the SI derived unit of electric potential difference. The number of volts is a measure of the strength of an electrical source in the sense of how much power is produced for a given current level. It is named in honor of Alessandro Volta (1745–1827), who invented the voltaic pile, the first chemical battery.

International danger high voltage symbol.

Definition

Josephson junction array chip developed by NIST as a standard volt.

The volt is defined as the potential difference across a conductor when a current of one ampere dissipates one watt of power. Hence, it is the base SI representation m² · kg · s^-3 · A^-1, which can be equally represented as one joule of energy per coulomb of charge, J/C.

1 V = 1 W/A = 1 m²·kg·s^–3·A^–1

Since 1990 the volt is maintained internationally for practical measurement using the Josephson effect, where a conventional value is used for the Josephson constant, fixed by the 18th General Conference on Weights and Measures as

K_{J-90} = 0.4835979 GHz/µV.

Explanation

The electrical potential difference can be thought of as the ability to move electrical charge through a resistance. In essence, the volt measures how much kinetic energy each electron carries. The number of electrons is measured by the charge, in coulombs. Thus the volt is multiplied by the current flow, in amperes which are one coulomb per second, to yield the total electrical power in the current, in Watts. At a time in physics when the word force was used loosely, the potential difference was named the electromotive force or emf - a term which is still used in certain contexts.

Electrical potential difference ("voltage")

Between two points in an electric field, such as exists in an electrical circuit, the potential difference is equal to the difference in their electrical potentials. This difference is proportional to the electrostatic force that tends to push electrons or other charge-carriers from one point to the other. Potential difference, electrical potential and electromotive force are measured in volts, leading to the commonly used term voltage and the symbol V (sometimes ${\mathcal {E}}$ is used for voltage).

Voltage is additive in the following sense: the voltage between A and C is the sum of the voltage between A and B and the voltage between B and C. Two points in an electric circuit which are connected by an ideal conductor, without resistance and without the presence of a changing magnetic field, have a potential difference of zero. But other pairs of points may also have a potential difference of zero. If two such points are connected with a conductor, no current will flow through the connection. The various voltages in a circuit can be computed using Kirchhoff's circuit laws.

Voltage is a property of an electric field, not individual electrons. An electron moving across a voltage difference experiences a net change in energy, often measured in electron-volts. This effect is analogous to a mass falling through a given height difference in a gravitational field.

Hydraulic analogy

If one thinks of an electrical circuit in analogy to water circulating in a network of pipes, driven by pumps in the absence of gravity, then the potential difference corresponds to the fluid pressure difference between two points. If there is a pressure difference between two points, then water flowing from the first point to the second will be able to do work, such as driving a turbine.

This hydraulic analogy (see separate article for full details) is a useful method of teaching a range of electrical concepts. In a hydraulic system, the work done to move water is equal to the pressure multiplied by the volume of water moved. Similarly, in an electrical circuit, the work done to move electrons or other charge-carriers is equal to 'electrical pressure' (an old term for voltage) multiplied by the quantity of electrical charge moved. Voltage is a convenient way of quantifying the ability to do work.

Technical definition

The electrical potential difference is defined as the amount of work per charge needed to move electric charge from the second point to the first, or equivalently, the amount of work that unit charge flowing from the first point to the second can perform. The potential difference between two points a and b is the line integral of the electric field E:

$V_{a}-V_{b}=\int _{a}^{b}\mathbf {E} \cdot d\mathbf {l} =\int _{a}^{b}E\cos \phi dl.$

Useful Formulae

DC Circuits

$V={\sqrt {PR}}$

$V={\frac {P}{I}}$

$V=IR\!\$

Where V=Voltage, I=Current, R=Resistance, P=Power

AC Circuits

$V={\frac {P}{IZ\cos \theta }}$

$V={\frac {\sqrt {PZ}}{\sqrt {\cos \theta }}}\!\$

$V={\frac {\sqrt {PR}}{\cos \theta }}$

Where V=Voltage, I=Current, R=Resistance, P=Power, Z=Impedance, θ=Phasor Angle

AC Conversions

$V_{avg}=.637V_{pk}\!\$

$V_{rms}=.707V_{pk}\!\$

$V_{ppk}=.354V_{rms}\!\$

$V_{avg}=3.142V_{ppk}\!\$

$V_{rms}=.9V_{avg}\!\$

$V_{pk}=.5V_{ppk}\!\$

Where Vpk=Peak Voltage, Vppk=Peak-to-Peak Voltage, Vavg=Average Voltage, Vrms=Effective Voltage

Total Voltage

Voltage sources in series:

$V_{T}=V_{1}+V_{2}+V_{3}+...\!\$

Voltage sources in parallel:

$V_{T}=V_{1}=V_{2}=V_{3}=...\!\$

Voltage Drops

Across a resistor (Resistor n):

$V_{n}=IR_{n}\!\$

Across a capacitor (Capacitor n):

$V_{n}=IX_{n}\!\$

Across an inductor (Inductor n):

$V_{n}=IX_{n}\!\$

Where V=Voltage, I=Current, R=Resistance, X=Reactance

Examples

Voltage sources

Symbolic representation of a voltage source.

Common sources of emf include:

• the battery
• the dynamo (a potential difference is generated between the ends of an electrical conductor that moves perpendicularly to a magnetic field)
• electrostatic induction (as when two different electrically insulating materials are rubbed together to produce an electrostatic discharge)
• the capacitor (really a storage device for energy produced by an emf from another source)

Common voltages

1.5 volt C-cell batteries

Nominal voltages of familiar sources:

• Nerve cell action potential: 40 millivolts
• Single-cell, non-rechargeable battery (e.g. AAA, AA, C and D cells): 1.5 volts
• Automobile electrical system: 12 volts
• Household mains electricity: 120 volts North America, 230 volts Europe ^[1]
• Rapid transit third rail: 600 to 700 volts ^[2]
• High voltage electric power transmission lines: 110 kilovolts and up (1150 kV is the record as of 2005)
• Lightning: 100 megavolts

Measuring instruments

A multimeter set to measure voltage.

Instruments for measuring potential differences include the voltmeter, the potentiometer (measurement device), and the oscilloscope. The voltmeter works by measuring the current through a fixed resistor, which, according to Ohm's Law, is proportional to the potential difference across it. The potentiometer works by balancing the unknown voltage against a known voltage in a bridge circuit. The cathode-ray oscilloscope works by amplifying the potential difference and using it to deflect an electron beam from a straight path, so that the deflection of the beam is proportional to the potential difference.

History of the volt

In 1800, as the result of a professional disagreement over the galvanic response advocated by Luigi Galvani, Alessandro Volta developed the so-called Voltaic pile, a forerunner of the battery, which produced a steady electric current. Volta had determined that the most effective pair of dissimilar metals to produce electricity was zinc and silver. In the 1880s, the International Electrical Congress, now the International Electrotechnical Commission (IEC), approved the volt for electromotive force. The volt was defined as the potential difference across a conductor when a current of one ampere dissipates one watt of power.

Prior to the development of the Josephson junction voltage standard, the volt was maintained in national laboratories using specially constructed batteries called standard cells. The United States used a design called the Weston cell from 1905 to 1972.

See also

• Alternating current (AC)
• Direct current (DC)
• Electric shock
• High-voltage
• ^ List of countries with mains power plugs, voltages and frequencies
• ^ List of current systems for electric rail traction
• Mains electricity (an article about domestic power supply voltages)
• Ohm's Law
• SI for unit prefixes
• SI electromagnetism units